To start, gather 12 of your 27 1/4"x 1/2" pre cut pieces of pvc pipe and 8 of your 1/2" 3-way Ls.

Connect 4 of your 3-way Ls and 4 of your 27 1/4"x 1/2" pre cut pieces of pvc pipe to complete as seen in picture. Repeat this step.

Take both of the square shapes that you made from the previous step and connect using 4 more of the 27 1/4"x 1/2" pre cut pieces of pvc pipe to complete a 3D square.

Now take the last 8 of 27 1/4"x 1/2" pre cut pieces of pvc pipe and add a 1/2" Spears snap-on tee to each end.

Start adding the pieces that you made in the previous step to the center of each side. The edge of each snap-on tee should be spaced 9 1/4" away from the edge of the 3-way L. The width between each up right should be 6" (the width of your Gutter Guard.

Take 4 of your precut 1/2" x 13" pvc pipe and pushe them into the 1/2" 4-way cross. Now take 4 of your 1/2" Spears Snap-on Tees and glue them on each end as seen in the picture.

Click image to enlarge

Click image to enlarge

Click image to enlarge

Click image to enlarge

Click image to enlarge

Click image to enlarge

Click image to enlarge

Click image to enlarge