Picture to the left shows most of your precut pieces and parts needed.

Gather your 5-way cross, (5) for your 1 1/4" to 3/4" bushing reducers, (5) 3/4"x16" lengths of schedule 40 pvc pipe

Insert all (5) of your bushings into your 5-way cross

Now insert your 16" x 3/4" pieces. This is your first stand. Repeat this process.

Take a 10" x 3/4" piece of pvc pipe and glue a 3/4" Spears snap-on tee to each end as seen in the picture.

Take two 10' x 3/4" pieces of pvc pipe and glue a 3/4" Spears snap-on tee to each end as seen in the picture.

Sit the two stands in front of these 10' lengths

Snap one of the 10' lengths onto the bottom of each stand. Click on the image and you will see a piece holding up the center. This is a 3/4" snap-on tee, 3" length of 3/4" pipe and a 3/4" tee glue together. This is to keep the center from sagging.

Now add your top 10' length and snap the 10" piece you made earlier to the center. You can pick up the whole assembly and not have to worry about it falling apart. It is ver sturdy.

Now add your Snap-N-Glow and you are ready to go!

P.S. Don't forget to paint your stand flat black to hide it in the dark.